Gateway 920 User Manual page 63

5
While holding the retention cover open, remove the expansion card. You
can slightly seesaw the card end-to-end to loosen the card, but do not bend
the card sideways.
Warning
6
While holding the retention cover open, press the new card into the
expansion slot. You can slightly seesaw the card end-to-end to help insert
the card, but do not bend the card sideways.
7
Push the retention cover in, then tighten the thumbscrew.
8
Connect any cables to the card by following the instructions in the card
documentation.
9
Close the server case by following the instructions in
case" on page 44.
10
See the documentation that came with the card for any special software
installation instructions.
Do not touch the contacts on the bottom part of the
expansion card. Touching the contacts can cause
electrostatic damage to the card.
www.gateway.com
Installing PCI expansion cards
"Closing the server
57