Operation; Preparation Of The Device; Functional Control - Bartscher GMS600 Manual

5.2 Operation

5.2.1 Preparation of the device


The device should be thoroughly cleaned before the first use. Follow instructions
in section 8 "Cleaning"

Place the included container under the outlet hole with magned towards
inside (fig. 6).

When the cutter is equipped with feeder (not included in the delivery), install it under
the outlet hole. For correct installation insert bolts into the feeder holes and press the
feeder down until it is firmly hanged (fig. 7). Cut products will be delivered to the
container under the feeder.
Sensor

5.2.2 Functional control

Before cutting vegetables it is required to check all functions:
f) First press Start "I", then Stop "O", and check operation of appropriate
indicator lamps (fig. 8).
g) Lift and press the pusher down to check if motor turns off and on.
h) Check if after loosening the lid the device turns off and if after fixing it and
pressing Start "I" the device turns on again.
i) Check if with correctly fixed container (or feeder) and after pressing Start "I" the
device turns on.
j) Check if after removing the container (or feeder)the device turns off.
- 44 -
.
Fig. 6
Pushbutton
Start "I"
Pushbutton
Stop "O"
Fig. 7
Fig. 8 - Switches