Installation And Operation; Installation - Bartscher GMS600 Manual

The vegetable cutter is moreover equipped with circuit consisting of:
D
Control panel
Protection degree IP 54, with low-voltage
supply, consisting of two switches (fig. 5).
"I" = pushbutton Start
"O" = pushbutton Stop
E
Power supply PCB
Water resistance level IPX3 - protection consisting of transformer and two
relays, controlled by sensors located on container, feeder, and lid, used for
turning on and off.
The vegetable cutter is equipped with the contactor switch which protects
the device from self-activation after the power supply failure.

5. Installation and operation

5.1 Installation

CAUTION!
Any installation, connection and maintenance work related to the device must
be performed by the qualified and certified technician in accordance with the
applicable international, national and local regulations.
Positioning

Unpack the device and discard the entire packaging material according to the
regulations valid in the country of installation.

Place the device on an even, stable, dry and waterproof and heat-resistent surface.

Never place the device on an inflammable surface.

Never place the device in wet or damp locations.

Do not place the device near open flame, electric heaters or other heat source.
- 42 -
Fig. 5 - Switches
Start "I" and Stop "O"