Advertisement
8. Move the pointer to MAIN TRANS TEMP:XXX and press the Select key. The
HDT will display a list of transmissions that may be installed in the vehicle:
9. Move the pointer next to the name of the transmission type that is installed in the
vehicle, then press the Select key. The HDT will display:
10. Return to the MAIN MENU by pressing the Return key once.
11. Store the Main Transmission Type value in the Interface Module by moving the
pointer to WRITE CONFIG and then pressing the Select key. The HDT will display:
a.
If the value was successfully stored, the HDT will display the MAIN
MENU. At that point you can use the Return key to go back to previous
menus. When finished, unplug the tool.
b. If instead the HDT displays SYSTEM ERROR, turn the ignition off and
back on, then repeat this procedure from the beginning.
12. When finished, disconnect the HDT from the vehicle.
13. To verify you set the correct value, go to Section 6.5 on page 8.
Advertisement
