Digital Projection
Connecting the projector
connection panel
Signal Inputs
The following inputs are available:
4. SDI
1. RGB1
7. Component
EDID handshaking on the DVI and rGB2 inputs
If you are using a computer DVI card or other source that obeys the EDID
handshaking protocol, then the card or source will automatically configure itself to
suit the projector.
If not, then you should refer to the documentation supplied with the source to
manually set the resolution to 1400 x 1050 or the nearest suitable setting. Switch off
the source, connect to the projector, then switch the source back on again.
Rev C August 2009
Downloaded From projector-manual.com Digital Projection Manuals
User Manual
TITAN sx+600/700.
Input
connection panel
5. Composite Video
Control
3. DVI
2. RGB2
6. S-Video
2. Installation
Notes
For more information on
selecting an input source, see
section 4. Overview, Using
the control keys, and Using
the menus.
For more information about pin
connections and control codes
see section 7. Appendix.
For more information on
input modes see section
4. Overview.
Page 2.15