2N EasyGate PRO User Manual page 38

Max ring time for CallBack (Function No. 502)
The parameter sets up the CallBack behavior. There are 2 options for using CallBack on the FXS
port:
Simple CallBack – set to 0. During an incoming call, the FXS port gives a ringing. When the FXS
port is off-hooked, an incoming GSM call is rejected and after 10 s the gateway calls back the
GSM number. During those 10 s the caller must hang up to be ready for answering the callback.
On the FXS port a melody is played.
Advanced CallBack – set to 1–255. During an incoming call, the FXS port gives a ringing. To use
the CallBack functionality, the caller must hang up before the parameter Max. ring time for
CallBack runs out. The gateway then calls back immediately. If the call is answered on the
analog side earlier, the called party hears the melody. If the call is answered on the GSM side
first, then the calling party hears the melody. In order not to use the CallBack, the caller just
does not hang up and the call is handled as a standard incoming call.
Setting options: 0–255 s
Setting step: 1 s
Default setting: 5 s
FAX from GSM route to (Function No. 509)
You can route an incoming GSM FAX call to the phone line FXS or to a serial line (PCFax). The
parameter takes place only on models with ac FAX converter, otherwise the FAX calls are always
routed to a serial line.
Setting options:
-FXS line – Incoming FAX call is routed to FAX machine on FXS line.
-COM – Incoming FAX call is routed to serial line.
Default setting: FXS line
DATA from GSM route to (Function No. 508)
You can route an incoming GSM DATA call to the telephone line FXS or to a serial line. The
parameter takes place only on models with a FAX/DATA converter, otherwise the DATA calls are
always routed to a serial line.
Setting options:
-FXS line – Incoming DATA call is routed to modem on FXS line.
-COM – Incoming DATA call is routed to COM.
Default setting: FXS line
User Guide 2N® EasyGate PRO
38 / 87