2N EasyGate PRO User Manual page 30

Ringing Signal Settings
Ringing signal – frequency [Hz] (Function No. 140)
Ringing signal frequency setting.
Setting options: 25 / 50 Hz - EasyGate rings with 50 or 25 Hz on FXS interface.
Default setting: 50 Hz
Ringing signal – cadence (Function No. 141)
Ringing signal cadency setting.
Setting options:
1000/4000 ms (0) – 1 s ring, 4 s pause
400/200/400/2000 ms (1) – 400 ms ring, 200 ms pause,
400 ms ring, 2 s pause1500/3500 ms (2) – 1.5 s ring, 3.5 s pause
2000/4000 ms (3) – 2 s ring, 4 s pause
Default setting: 1000/4000 ms
Ringing signal – cadence for data/fax (Function No. 142)
Ringing signal cadency setting for incoming fax call data.
The same setting as parameter 141.
CLI transmitting (Function No. 148)
Set this item to enable/disable identification of a telephone line calling from a GSM network. The
function can be enabled if the device on your telephone line is capable of receiving FSK
according to ETSI standards.
Setting options: Disable (0) – EasyGate does not transmit the CLI.
FSK during ringing (1) – EasyGate transmits the FSK-based CLI according to the
ETSI EN 300 659 standard (transmission during ringing).
Default setting: Disable
Replace character + in CLI by (Function No. 149)
If this parameter is fulfilled, the + character in the international prefix of CLI is replaced by the
defined string. The + character can neither be transmitted by the FSK protocol nor DTMF dialed
from a terminal.
Setting options: 0–4 characters (0–9, *, #)
User Guide 2N® EasyGate PRO
30 / 87