Setting the Tool
Set the type and offset value of the tool that is used in each of the tool condition numbers.
Operation
1
Press the [CONDITION] key in the default screen.
CONDITION setting screen (1/3) is displayed.
2
Press the [2] key (TOOL).
TOOL setting screen is displayed.
3
Press the [1] key.
CONDITION No. selection screen is displayed.
* Display may vary depending on the selected condition number.
4
Press the POSITION (▲▼) key and select the condition number
(CONDITION No.).
5
Confirm the setting and press the POSITION (◄) key
(PREVIOUS).
CONDITION No. will get set and return to TOOL setting screen.
Next page
Supplement
It will return to CONDITION screen without
changing the settings when you press the
POSITION (◄) key (CANCEL).
POSITION
POSITION
2-26