10
Press the [1] key (COPY SPACE X).
The COPY SPACE X setting screen is displayed.
For setting COPY SPACE Y, Press the [2] key in step 10 above.
COPY SPACE Y can be set in the same way as COPY SPACE X.
11
Press the POSITION (▲▼) key and increase or decrease the
setting value.
12
Confirm the setting and press the POSITION (◄) key
(PREVIOUS).
Copy space will be selected, and it will return to COPY mode
screen.
13
Press the [3] key (CROSS CUT).
The CROSS CUT setting screen is displayed.
14
When [1] is pressed, "OFF" is selected. When [2] is pressed, "ON"
is selected.
Press [2] to select "ON" and press the [ENTER] key to determine the setting.
15
On the COPY MODE setting screen, press the [4] key (CROSS
CUT SPACE).
The CROSS CUT SPACE screen is displayed.
Increase or decrease the setting value with the POSITION (▲▼)
keys.
16
Confirm the setting and press the [ENTER] key (SET).
"COPY" is displayed on the screen, and it will copy as much as specified.
4-17
POSITION
POSITION
Supplement
l
Digits of settings can be changed by pressing
the [FAST] key.
POSITION
l
The settable range is 5.0 mm to 999.0 mm.
Supplement
Cutting data is stored even if the media is
exchanged. It can be copied as many times until
the buffer memory is cleared. It can be copied
again after exchanging the media by pressing
[COPY] key.