Setting The Carrier Address Id - Avaya G650 Installing

Setting the carrier address ID

Set the carrier address ID either before or after installing each G650 Media Gateway. Set the
carrier address by inserting the address paddleboard in one of five connector slots on the
upper-right side of the backplane. The slots are clearly marked as A, B, C, D, and E. All carriers
ship with the address paddleboard in connector slot A. If you are working on a B, C, D, or E
carrier, you need to remove the address paddleboard. Then move the paddleboard to the
correct slot for a B, C, D, or E carrier.
To set the carrier address ID:
1. Loosen the thumb screws on the fan assembly and pull it straight out as shown in
Figure 3: Removing the fan assembly
connection. Place the assembly on top of the cabinet or hang it from the rear connector
panel using the screws on the back of the assembly. Leave the fan assembly off until the
unit is completely installed in the rack.
2. Verify and, if necessary, set the carrier address ID for each G650 Media Gateway as shown
in Figure 4: Setting the G650 Media Gateway carrier address ID
address paddleboard in the connector slot that you want: A, B, C, D, or E.
Figure 3: Removing the fan assembly
34 Installing the Avaya G650 Media Gateway
fndprem2 LAO 071503
on page 34. You do not need to unplug the
on page 35. Place the