Cabling The Fifth Media Gateway - Avaya G650 Installing

Hide thumbs Also See for G650:

Installing (258 pages)

Getting started (21 pages)

Specifications (2 pages)

Table Of Contents

Table of Contents

3. Remove the nuts on the posts of the plates covering the bottom right TDM/LAN cable

routing slot of media gateway D and the top right TDM/LAN cable routing slot of media

gateway C.

4. Remove the left slot cover on top of media gateway C and the lower-left slot cover of media

gateway D to open the slots.

5. Pull open the EMI gasket, and pass the TDM/LAN bus cable through the routing slots in

both media gateways. Push the free end of the EMI gasket back in place.

6. In media gateway C, install the lower connector of the TDM/LAN bus cable on the right end

of the TDM/LAN bus. Ensure that the arrows on the back of the cable terminators point

upward.

7. In media gateway D, install the upper connector of the TDM/LAN bus cable on the right end

of the TDM/LAN bus.

8. Flip over the routing slot plates and reinstall both plates. Once you reinstall the plates, the

ends of the routing slots are covered.

9. Perform one of the following actions:

If the system includes only four media gateways, reinstall the fan assemblies and

●

tighten the seven screws. Tighten all knurled screws securely so that the screws

cannot be loosened without the use of a tool.

If the system includes more than four media gateways, continue with

●

media gateway