Fantasea Line FG7X III R Instruction Manual page 26

b. Red flashing – The housing failed the check. Inspect the housing for potentia
sources. If failing to find the source, it is recommended to reinstall and lock all system sources. If failing to find the source, it is recommended to reinstall and lock all system sources. If failing to find the source, it is recommended to reinstall and lock all system
components, visually inspect all o-rings and make sure nothing interferes with the components, visually inspect all o
watertight seal of the housing. watertight seal of the housing.
11. If during the analysis the LED Indicator If during the analysis the LED Indicator starts flashing in yellow or alternately red and green, the
analysis has been interrupted by over-pressure or under-pressure correspondingly. Follow the analysis has been interrupted by over
steps below to allow the analysis to properly continue: steps below to allow the analysis to properly continue:
a. Yellow flashing - Use the Vacuum Pump to extra
steady yellow.
b. Red and Green flashing Red and Green flashing - Release a bit of the vacuum by turning the Vacuum Release Tip
counterclockwise and pulling it out (image # counterclockwise and pulling it out (image #21) until the LED Indicator turns steady
yellow.
12. In case of a significant air leakage detected anytime during the process, the LED Indicator will ficant air leakage detected anytime during the process, the LED Indicator will ficant air leakage detected anytime during the process, the LED Indicator will
turn flashing red.
Pre-Dive Check LED Indicator Diagram Dive Check LED Indicator Diagram
Flashing
Yellow
Continue
Pumping
Flashing Green =
Housing ready to
dive
13. Once the pre-dive check is complete and the dive check is complete and the watertight seal of the housing has been confirmed:
a. Reinstall the Protective Cap over the Vacuum Valve if it hasn't been reinstalled yet. Note einstall the Protective Cap over the Vacuum Valve if it hasn't been reinstalled yet. Note einstall the Protective Cap over the Vacuum Valve if it hasn't been reinstalled yet. Note
that the Vacuum Valve is watertight even without the Protective Cap, as long as the that the Vacuum Valve is watertight even without the Protective Cap, as long as the that the Vacuum Valve is watertight even without the Protective Cap, as long as the
Vacuum Release Tip isn't pulled out during the dive. However, the Protective Cap ensures
The housing failed the check. Inspect the housing for potential leakage The housing failed the check. Inspect the housing for potentia
rings and make sure nothing interferes with the
starts flashing in yellow or alternately red and green, the
Use the Vacuum Pump to extract air again until the LED indicator turns
Release a bit of the vacuum by turning the Vacuum Release Tip
Steady Steady
Yellow Yellow
4-min. Vacuum min. Vacuum
Analysis in progress Analysis in progress
Flashing Red =
Housing Failed
isn't pulled out during the dive. However, the Protective Cap ensures isn't pulled out during the dive. However, the Protective Cap ensures
pressure correspondingly. Follow the
ct air again until the LED indicator turns
) until the LED Indicator turns steady
Flashing
Red/Yellow
Release Vacuum
with Valve Lock
Check
watertight seal of the housing has been confirmed:
FG7X III R Housing Instruction Manual
26
Flashing
Red
Inspect housing Inspect housing
for source of
leakage
Instruction Manual 20200220