Fantasea Line FG7X III R Instruction Manual page 22

Identification of System Parts
* With a Vacuum Valve installed on the housing's dedicated M16 port a Vacuum Valve installed on the housing's dedicated M16 port
Vacuum Valve
Protective Cap
Charging the Unit
1. Turn the unit on using the power switch featured on the Signal Turn the unit on using the power switch featured on the Signal
Board.
2. The LED Indicator will start flashing blue: Indicator will start flashing blue:
a. Slow flashing (approx. 1 flash per second) indicates a Slow flashing (approx. 1 flash per second) indicates a
charged battery.
b. Rapid flashing (approx. 4 flashes per second) indicates low Rapid flashing (approx. 4 flashes per second) indicates low
battery.
3. To charge the unit, connect it to a USB charger using a standard To charge the unit, connect it to a USB charger using a standard
Micro-USB cable (not included). Note that it is best using able (not included). Note that it is best using an
android phone charger unit for this purpose.
4. Connect the micro-USB end of the cable to the
the Signal Board (image #16). Connect the other end of the cable to
a USB port or USB charger.
5. The unit should start charging and the The unit should start charging and the LED Indicator should start flashing green
6. Make sure to keep the unit turned on during charging. Make sure to keep the unit turned on during charging.
7. When charging is complete, the When charging is complete, the LED Indicator stops flashing and remains green
8. Disconnect the cable and turn the unit off using the power switch on the Signal Board to save
battery power. If the unit is left turned on, the battery will drain within a few days. battery power. If the unit is left turned on, the battery will drain within a few days. battery power. If the unit is left turned on, the battery will drain within a few days.
9. During charging, keep the charger away from highly flammable materials or products and never
leave the charger unattended when in use charger unattended when in use.
10. Never apply any type of pressure on the battery, expose it to direct heat or chemicals. Never apply any type of pressure on the battery, expose it to direct heat or chemicals. Never apply any type of pressure on the battery, expose it to direct heat or chemicals.
11. Battery must not be charged in temperatures below freezing or above Battery must not be charged in temperatures below freezing or above 50°C (122°F)
(Housing Back Door Exterior)* (Housing Back Door
Vacuum
Release Tip
for this purpose.
USB end of the cable to the Micro-USB port on
Connect the other end of the cable to
n the unit off using the power switch on the Signal Board to save n the unit off using the power switch on the Signal Board to save
keep the charger away from highly flammable materials or products and never keep the charger away from highly flammable materials or products and never
Vacuum Valve
should start flashing green.
stops flashing and remains green.
FG7X III R Housing Instruction Manual
22
Image #16
50°C (122°F).
Instruction Manual 20200220