Setting Up The Housing; Preparing The Camera; Preparing The Housing - Fantasea Line FG7X III R Instruction Manual

25. Removable Anti-Glare Hood – The anti
shooting in bright conditions. It can be removed and installed during the dive. For further shooting in bright conditions. It can be removed and installed during the dive. shooting in bright conditions. It can be removed and installed during the dive.
instructions, please refer to the section "Preparing the Housing". instructions, please refer to the section "Preparing the Housing".
SETTING UP THE HOU UP THE HOUSING
Note

PREPARING THE CAMERA

1. Install a (preferably empty) memory card
battery inside the camera.
2. Remove the camera strap from the camera if one was installed.
3. Rotate the Mode Dial so the Auto shooting mode is selected a Rotate the Mode Dial so the Auto shooting mode is selected and aligned with the white mark on
the left of the wheel. This will allow for the camera and housing mode dials to be aligned, so the
housing mode dial will indicate the proper mode selected by the camera
4. It is recommended to program the camera to the It is recommended to program the camera to the most frequently used underwater photo mode,
lighting and other key settings prior to installing the camera in the housing. lighting and other key settings prior to installing the camera in the housing.

PREPARING THE HOUSING

1. When using the housing for the first time When using the housing for the first time-
a. Peel the transparent plastic
b. Install the hand lanyard on the housing by Install the hand lanyard on the housing by inserting it through the lanyard loop on the
bottom right of the housing (facing from back), then pulling it through itself and test bottom right of the housing (fa
in order to make sure it is secure
c. Install the housing side of the diffuser quick release secure tall the housing side of the diffuser quick release secure line by tying it around the
upper rectangular loop at the top left side of the housing, where the Fiber Optic Cable upper rectangular loop
Plate secure string is attached to as well (image #2). Please note that this line Plate secure string is attached to
assembled and then there is no need for installation. assembled and then there is no need for installation.
The anti-glare hood enables a better view of the LCD screen when
It is important that a first dive is always carried out with the housing It is important that
empty (no camera installed inside) in order to verify that the housing empty (no camera installed inside)
watertight seal has not been affected during transport and watertight seal has not been affected during transport and after long
periods of storage. periods of storage.
memory card (16 GB+ capacity recommended) and a fully charged
rom the camera if one was installed.
This will allow for the camera and housing mode dials to be aligned, so the This will allow for the camera and housing mode dials to be aligned, so the
indicate the proper mode selected by the camera dial.
transparent plastic screen protector off the back door exterior
to make sure it is secure (image #1).
glare hood enables a better view of the LCD screen when
carried out with the housing
in order to verify that the housing
most frequently used underwater photo mode,
inserting it through the lanyard loop on the
left side of the housing, where the Fiber Optic Cable
Please note that this line may come
FG7X III R Housing Instruction Manual
12
and a fully charged
nd aligned with the white mark on
terior of the housing.
it through itself and testing it
by tying it around the
Instruction Manual 20200220