Fantasea Line FG7X III R Instruction Manual page 13

d. If making use of the Hybrid Vacuum Safety System, install the vacuum valve on the If making use of the Hybrid Vacuum Safety System, install the vacuum valve on the If making use of the Hybrid Vacuum Safety System, install the vacuum valve on the
housing. Please refer to the "Hybrid Vacuum Safety System" section for instructions. housing. Please refer to the "Hybrid Vacuum Safety System" section for instructions. housing. Please refer to the "Hybrid Vacuum Safety System" section for instructions.
e. Open the housing (see
System") and remove the anti and remove the anti-glare hood out of the housing. Secure the anti
to the housing by tying its secure string around the lower rectangular loop at the bottom to the housing by tying its secure string
left side of the housing. left side of the housing. Install the anti-glare hood over the anti-glare hood r
back of the housing. First install the anti-glare hood over the top rail (image #3) and then back of the housing. First install the anti
gently and carefully stretch it downwards to install it on the bottom rail gently and carefully stretch it downwards
sitting securely on both upper and lower curely on both upper and lower rails (image #4).
f. It is important that a first dive with the housing is
order to verify that the housing watertight seal has not been affected during transport order to verify that the housing watertight seal has n
and after long periods of storage long periods of storage.
see section "Opening the Housing" and "Hybrid Vacuum Safety
glare hood over the top rail (image #3) and then
first dive with the housing is always made without the camera in
Image #1
Image #3
13
and "Hybrid Vacuum Safety
Secure the anti-glare hood
ctangular loop at the bottom
to install it on the bottom rail, making sure it's
made without the camera in
ot been affected during transport
FG7X III R Housing Instruction Manual
glare hood rails at the
Image #2
Image #4
Instruction Manual 20200220