Mount The Origin Marker; Mount The Origin Marker - Centurion D3 Installation Manual

Mount the origin marker:

11. Close the gate completely.
12. Mount the origin marker to the rack (Figure 18) at least 500mm from the origin sensor (Figure 19).
If a CE chip is fitted to the control card (Figure 17), mount the origin marker at least 1000mm from
the origin sensor to allow for the longer crawl distance.
If the crawl distance feature of the control card (page 44) has been changed from the default
value of 1, the origin marker position must be
value.
The position of the origin marker affects how far the gate will open for the PEDESTRIAN opening
feature. Locating the marker at a distance greater than the recommended distance will increase
the pedestrian opening.
CENTURION SYSTEMS CP80 V1.2
MOTOR - BATTERY +
Figure 17 Chip Identification
Steel Rack
BOLT USING
FASTENERS
PROVIDED
ORIGIN MARKER
BRACKET
WELD MOUNTING
BRACKET PROVIDED TO
Figure 18 Mounting the Origin Marker
CHARGE
(LED)
DC CHARGER
INPUT
AUXILIARY FUSE 3A F/B
LIGHT COM COM
VIEWED FROM MOTOR SIDE
STEEL RACK
increased
L1 L2
(LED)
TEST
MICRO CONTROLLER
CHIP VERSION: D5 Vxx
SERIAL #
STATUS
(LED)
(LED's)
12V TRG IRB FRX LED PED LCK SET
RAZ Rack
DRILL HOLES IN RACK
TO MOUNT ORIGIN MARKER
Page 22
by at least 250mm x crawl setting
A CE chip fitted to the CP80
controller is indicated by
the version number ending
with the letters EU.
DOSS
MICRO CONTROLLER
CHIP VERSION: D5 VxxCE
Standard chip
MICRO CONTROLLER
SET
CHIP VERSION: D5 Vxx
BOLT USING
FASTENERS
PROVIDED