Centurion D3 Installation Manual page 28

20. L1 will flash once then go off, twice in short succession then go off, 3 times then go off, etc.
Release the TEST button
Example 1:
To set the MODE OF OPERATION to CONDOMINIUM (That is Feature number 4, to a status of 2
according to the table on page 43)
The L1 light will flash once and pause,
then flash twice and pause....
At this moment release the TEST
flashing 4 times and pausing to indicate that
NOTE
: The STATUS of the Feature is not changed yet, the feature has only been
selected to be changed!
21. If an incorrect Feature is selected, then remove and re-apply power and re-start from step 3. None of
the Feature settings will have been altered at this stage.
Changing the STATUS or COUNT value of a Feature.
22. To set the STATUS
mode or Pre-flashing features:
Press and hold the TEST
same as for selecting a Feature. (See Step 4) Release the TEST button when the number of flashes is
the same as the STATUS value required.
Example 1 (continued)
To set the MODE OF OPERATION to CONDOMINIUM:
After selecting the Feature, again
STATUS light:
The L1 light will flash once and pause,
At this moment release the TEST
has been changed to condominium.
NOTE:
Only after setting the STATUS, would the mode of operation be changed to
CONDOMINIUM!
L2 will come back on, indicating that the STATUS has been updated.
23. To set the COUNT
timer, Auto-close override timer, Pre-flashing time or Collision counter features:
Press and hold the TEST
when the number of flashes is the same as the Feature number to select.
Press and hold
then flash 3 times and pause....
then flash 4 times and pause....
button to select Feature 4. L2 will turn off, and L1 will keep on
value of the Auto Close, Mode of Operation, Collision Sensitivity, Positive Close
button while monitoring the STATUS light. The STATUS light will flash the
:
press and hold
then flash twice and pause.....
button to give a STATUS value of 2. The mode of operation
value of the Auto-close timer, Pedestrian Auto-close time, Courtesy light
button while monitoring the STATUS light. After a slight pause, the
the TEST button while monitoring L1:
Feature 4 is selected
the TEST button while monitoring the
Page 28