Apply Warning Decals - Centurion D3 Installation Manual

Figure 19 Origin marker Location
13. Open the gate until the origin marker is in line with the origin sensor and adjust the clearance
between the origin sensor and origin marker to between 5 and 10mm (Figure 20). For optimum
performance, try and keep this distance as small as possible.
Figure 20 Origin Marker and Sensor Clearance
Apply Warning Decal
14. Apply the supplied warning decals to the gate as indicated on the reverse side of the decal.
GREATER THAN 500mm.
IF A CE CHIP IS FITTED, GREATER THAN 1000mm
(GATE SHOWN IN CLOSED POSITION)
ORIGIN MARKER
ORIGIN MARKER ORIENTATION
5 - 10mm
ORIGIN SENSOR
ORIGIN MARKER
ORIGIN SENSOR
Page 23
Pillar