Centurion D3 Installation Manual page 7

Read and understand all safety instructions
Step 1
Connect all wiring:
Step 2
Get into programming mode:
Step 3
Remove all power.
Fit the SET link.
Reapply power.
Set the gate limits:
Step 4
Move gate half way and engage.
Press and hold TEST, release after 1 flash of L1.
Press and hold TEST, release after 1 flash of
STATUS.
Check that gate will travel in the correct direction.
Exit programming mode:
Step 5
Remove the SET link.
Check gate operation
Step 6
Step 6 Perform installation hand over
When fault finding an existing installation, refer
to the FAULT FINDING GUIDE on page 35
Electrical Setup
Action
Page 7
Fast Track Fast Track
Page 24
Page 24
Page 27
Page 46
Page 5