Site Considerations; Required Tools & Equipment; Heed Necessary Site Considerations; Gather Required Tools And Equipment - Centurion D3 Installation Manual

Install the gate operator only if:
1. It will not pose a hazard to the public.
2. There is sufficient clearance to a roadway and/or public thoroughfares.
3. The installation will meet all municipal and/or local authority requirements once completed.
4. The gate mass, pull force and application is within the operator specifications (see page 10).
General considerations for the installation:
5. Always recommend the fitment of additional safety equipment such as safety edges and safety
beams, for additional protection against entrapment or other mechanical risks.
6. Check that no pipes or electrical cables are in the way of the intended installation.
7. Check for loose sandy soil if installing foundations, as the soil condition may require a larger
foundation.
8. Never fit the operator on the outside of the gate where the public has access to it.
9. Ensure there is sufficient drainage where the motor is located to guarantee that there is no water
build-up around the operator.
Required Tools & Equipment Required Tools & Equipment
Spade
Level
Pick
Side Cutters
Hacksaw
Figure 6 Required Tools and Equipment

Site Considerations

Site Considerations
Crimping Tool
and Pin Lugs
Screw Drivers:
3.5mm Flat
Pliers
Spanners
19mm
17mm
13mm
Hammer
Electric
Drilling
Masonry Bits - 6mm
Machine
Steel Bits 8,5mm/5,0mm/4,0mm
Not Normally Required
Plumb Bob
Page 14
Measuring Tape
G-Clamp
Welding
Machine
Soldering Iron