Electrical Set-Up; Control Box Installation - Centurion Vector2 Installation Manual

Electrical Set-up

Electrical Set-up
WARNING
1. Always check that the isolator in the mains supply to the gate is in the OFF position, before doing any
work.
2. Ensure that all low voltage systems (Less than 42.4V) are suitably protected from damage, by
disconnecting all sources of power such as chargers and batteries before doing any work.
3. All electrical work must be carried out according to the requirements of all applicable local electrical
codes. (It is recommended that a licensed electrical contractor perform such work.)
Secure control box to wall
1. Secure the control box to wall using the most
appropriate means.
Be sure to position the wall box so as not to
cause any hazards during and after the
installation.
Preferably mount the wall box:
• Out of direct sunlight.
• At a comfortable working height.
• Away from garden sprinklers etc.
• To allow easy access even when the
gate is open.
Connect all wiring
2. Connect all the cables as required to the
control card. See page 46 and page 47.
3. When wiring each operator back to the
controller housing, it is recommended to
mount a small junction box adjacent each
operator. Terminate the cable provided on the
operator into this junction box and then route a
new cable from the junction box to the
controller housing.
Step 1
For wiring diagram see page 46/47
Page 26
Wiring Diagram for Basic Operation Wiring Diagram for Basic Operation
THIN PURPLE
S Sens1 S Sens1
THIN BLUE or ORANGE
S Sens2 S Sens2
THIN PURPLE PURPLE PURPLE S Sens1
M Sens1 M Sens1
MASTER BLUE BLUE S Sens2
THIN BLUE or ORANGE PURPLE PURPLE M Sense2 PURPLE PURPLE M Sens1 M Sense2
THIN RED or GREY Sens+ BLUE BLUE M Sense2 THIN RED or GREY Sens+
BLUE BLUE
THIN BLACK Sens- RED RED Sens+ THIN BLACK Sens-
RED RED BLACK BLACK Sens-
Saf CLO Saf CLO
Saf CLO
BLACK BLACK Saf OPE Saf OPE
Saf OPE
Com Com Com
LCK/STP LCK/STP LCK/STP
TRG
TRG PED TRG
PED Com PED
Com FRX Com
LI T
FRX FRX
LED
LI T LI T
Com
LED Aux 12V LED
Com Com Saf Com
Aux 12V Sol Aux 12V
Li g ht 15 15
Com Saf Com Saf
SLAVE Li g ht 15 15
Sol Sol
PURPLE PURPLE Batt +
Li g ht Li g ht
BLUE BLUE Bat -
MTR M+
Li g ht Li g ht
RED RED MTR —
Batt + Batt +
BLACK BLACK MTR S+
Bat - MTR S- Bat -
THICK BLUE MTR M+ MTR M+
THICK BLACK MTR — MTR —
MTR S+ THICK BLUE MTR S+
MTR S- THICK BLACK MTR S-
Figure 15 Wiring Diagram Figure 15 Wiring Diagram
Page 36 Page 36 Page 37 Page 37
JUNCTION
BOX