Table of Contents
Advertisement
11 Mechanical installation
11
Mechanical installation
The operator is mounted on either side of the door header depending on type of doors. The door
is controlled with a push or pull arm system.
If a coordination unit is to be installed on a double door installation, mount the coordinator base
with rotor before mounting the transmission unit, see page 52.
Note! Consider all power wire entry locations and signaling wires before preparing back plate.
Make sure to mount the drive unit at measurement A and the control unit at measurement B. The
illustrations also show how to route the cables. If there are sharp edges after drilling the cable
outlets, chamfer the edges to avoid damage to the cables.
34
Issue 2021-06-07
1020527-DIen-3.0
Advertisement
Table of Contents
