Table of Contents
Advertisement
Intel® Server Board M50CYP2SB Family Technical Product Specification
8.
Storage Support
The Intel® Server Board M50CYP2SB family provides storage options not available on previous server board
generations.
The server board supports up to two server board mounted M.2 PCIe*/SATA SSDs. The server board Mini-
SAS HD (SFF-8643) connectors provide SATA SSD storage support.
The server board also provides various Non-Volatile Memory Express (NVMe*) storage options. NVMe*
optimized, high-performance scalable storage interface designed to address the needs of enterprise systems
that use PCIe*-based solid-state storage,
The NVMe* technology allows Intel server boards to take advantage of the levels of parallelism possible in
modern SSDs.
Additional Intel® VROC NVMe* and Intel® VROC SATA capabilities are available. The Intel® Server Boards
support Intel® VROC 7.5.
Support for different storage options varies depending on the configuration and/or available accessory
options installed. This chapter provides an overview of server board storage support.
8.1
Server Board SATA Support
The server board uses two chipset-embedded AHCI SATA controllers, identified as "SATA" and "sSATA". The
AHCI sSATA controller supports up to two 6 GB/s SATA III ports (sSATA 1 and sSATA 2) using two M.2 SSD
connectors. The AHCI SATA controller supports up to eight 6 GB/s SATA III ports on the server board. The
following table describes the SATA and sSATA feature support.
Feature
Native Command
Queuing (NCQ)
Auto Activate for direct
memory access (DMA)
Hot Plug Support
(U.2 Drives Only)
Asynchronous Signal
Recovery
6 Gb/s Transfer Rate
ATAPI Asynchronous
Notification
Host and Link Initiated
Power Management
Staggered Spin-Up
Command Completion
Coalescing
providing efficient access to non-volatile memory storage devices.
Table 33. SATA and sSATA Controller Feature Support
Description
Allows the device to reorder commands for more efficient
data transfers
Collapses a DMA Setup, then DMA Activate sequence into a
DMA Setup only
Allows for device detection without power being applied
and ability to connect and disconnect devices without prior
notification to the system
Provides a recovery from a loss of signal or establishing
communication after hot plug
Capable of data transfers up to 6 Gb/s
A mechanism for a device to send a notification to the host
that the device requires attention
Capability for the host controller or device to request Partial
and Slumber interface power states
Enables the host the ability to spin up hard drives
sequentially to prevent power load problems on boot
Reduces interrupt and completion overhead by allowing a
specified number of commands to complete and then
generating an interrupt to process the commands
RAID Mode
AHCI Mode
Intel® VROC
(SATA RAID)
Supported
Supported
Supported
Supported
Supported
Supported
Supported
Supported
Supported
Supported
Supported
Supported
Supported
Supported
Supported
Supported
Supported
N/A
is an
77
Advertisement
Table of Contents
