Table of Contents
Advertisement
Intel® Server Board M50CYP2SB Family Technical Product Specification
5.1.1
Configuring System Management Port Using <F2> BIOS Setup
1. During the system power-on POST process, press <F2> when prompted to go to the BIOS Setup
utility main menu page.
2. Navigate to the Server Management tab and select BMC LAN Configuration to enter the BMC LAN
Configuration screen
3. The system is configured using the BMC Dedicated Network Configuration
4. For an IPv4 network:
o If configuring the server management BMC LAN, scroll to Baseboard LAN configuration > IP
source and then select either Static or Dynamic. If Static is selected, configure the IP address,
Subnet mask, and Gateway IP as needed.
5. For an IPv6 network:
o If configuring the server management BMC LAN, scroll to Baseboard LAN IPv6 configuration > IP
source and then select Enabled. Then scroll to IPV6 source and select either Static or Dynamic. If
Static is selected, configure the IPV6 address, Gateway IPV6, and IPV6 Prefix Length as needed.
6. The default User Name and Password is admin/admin.
7. If there is a need to change the User and Password, select BMC User Settings to enter the User
Configuration screen
8. Under Add User, set the following settings as desired:
o User Name – Enter the desired name. Note that the anonymous user cannot be changed.
o User password – Enter the desired password twice.
o Channel No – Select the Channel
o Privilege – Select the privilege to be used. (Administrator privilege is required to use KVM or
media redirection)
9. Press <F10> to save the configured settings and exit BIOS Setup. The server reboots with the new
LAN settings.
(Figure
28).
Figure 28. BIOS Setup BMC LAN Configuration Screen
(Figure
29).
53
Advertisement
Table of Contents
