Preparing To Use The Sprayer - Toro 41593 Operator's Manual

This machine can also use a biodiesel blended fuel of up
to B20 (20% biodiesel, 80% petrodiesel). The petrodiesel
portion should be low or ultra low sulfur. Observe the
following precautions:
•
The biodiesel portion of the fuel must meet specification
ASTM D6751 or EN14214.
•
The blended fuel composition should meet ASTM D975
or EN590.
•
Painted surfaces may be damaged by biodiesel blends.
•
Use B5 (biodiesel content of 5%) or lesser blends in cold
weather.
•
Monitor seals, hoses, gaskets in contact with fuel as they
may be degraded over time.
•
Fuel filter plugging may be expected for a time after
converting to biodiesel blends.
•
Contact your distributor if you wish for more information
on biodiesel.
Filling the Fuel Tank
Fuel tank capacity: approximately 45 L (12 US gallons).
Note: The fuel tank features a fuel gauge which shows the
level of fuel in the tank—check the fuel gauge frequently.
1. Position the sprayer on a level surface.
2. Set the parking brake, stop the pump, stop the engine,
remove the key, and allow the engine to cool.
3. Clean the area around the fuel-tank cap
1. Fuel gauge
4. Remove the fuel-tank cap.
5. Fill the tank to about 2.5 cm (1 inch) below the top of
the tank, (bottom of the filler neck).
Note: This space in the tank allows fuel to expand.
Do not overfill.
6. Install the fuel tank cap securely.
7. Wipe up any fuel that may have spilled.
(Figure
Figure 23
2. Fuel-tank cap

Preparing to Use the Sprayer

Cleaning the Suction Strainer
Service Interval: Before each use or daily Clean the suction
1. Position the sprayer on a level surface, set the parking
brake, stop the pump, stop the engine, and remove the
key from the starter switch.
2. At the top of the sprayer tank, remove the retainer that
secures the hose fitting to attached to the large hose
and the strainer housing
1. Suction hose
23).
3. Remove the hose and hose fitting from the strainer
housing
4. Pull the suction strainer out of the strainer housing in
the tank
1. Suction strainer
5. Clean the suction strainer with clean water.
6. Insert the suction strainer into the strainer housing
until the strainer is fully seated.
25
strainer more often when using wettable
powders.
(Figure 24).
Figure 24
2. Retainer
(Figure 24).
(Figure 25).
Figure 25