Preparing To Use The Sprayer - Toro Multi Pro 1750 Operator's Manual

Preparing to Use the
Sprayer
Cleaning the Suction Filter
Service Interval: Before each use or daily—Clean the
suction filter. Clean the suction filter
(more often when using wettable
powders).
1. Park the machine on a level surface, engage the
parking brake, shut off the pump, shut off the
engine, and remove the key.
2. At the top of the sprayer tank, remove the
retainer that secures the hose fitting attached to
the large hose from the filter housing
Figure 13
1. Suction hose
3. Remove the hose and hose fitting from the filter
housing (Figure 13).
4. Pull the suction strainer out of the filter housing
in the tank (Figure
Figure 14
1. Screen vane
5. Clean the suction filter with clean water.
Important:
Replace the filter if it is damaged
or cannot be cleaned.
(Figure
2. Retainer
14).
2. Suction strainer
6. Insert the suction filter into the filter housing until
the filter is fully seated.
7. Align the hose and hose fitting to the filter
housing at the top of the tank, and secure fitting
and housing with the retainer that you removed
in step 2.
Cleaning the Pressure Filter
Service Interval: Before each use or daily—Clean
1. Park the machine on a level surface, engage the
parking brake, shut off the sprayer pump, shut
13). off the engine, and remove the key.
2. Align a drain pan under the pressure filter
(Figure 15).
g033577
1. Filter head
2. Gasket (bowl)
3. Filter element
3. Rotate the drain cap counterclockwise and
remove it from the bowl of the pressure filter
(Figure 15).
Note:
Allow the bowl to drain completely.
4. Rotate the bowl counterclockwise and remove
the filter head
5. Remove the pressure filter element
g033578
6. Clean the pressure filter element with clean
water.
Important:
or cannot be cleaned.
7. Check the gasket for the drain plug (located
inside the bowl) and the gasket for bowl (located
26
the pressure filter. Clean the
pressure filter (more often when
using wettable powders).
Figure 15
4. Gasket (drain plug)
5. Drain cap
6. Bowl
(Figure 15).
Replace the filter if it is damaged
g033293
(Figure 15).