Understanding The Drawing Package And Part Numbering System - Honeywell Precision Platform 4022 Series System Manual

Precision Platform 4022 Scanner
Understanding the drawing package and part
numbering system
viii
Honeywell assigns a part number to every part and assembly. In the Table
of Contents for the drawing package, there are several types of part
numbers. Each section in that Table of Contents corresponds to an 09
model number. The Document List (DL) preface indicates that it is the
document list associated with that particular model number.
For example, DL09402231 is the list of documents and drawings provided
to support the Da Vinci Precision Platform 4022 Scanner, model #
09402231. This list contains all of the documents and drawings required
for installing and servicing the product. When necessary, the
corresponding Bills of Material (BOMs) are also supplied. The BOMs
provide the part numbers, descriptions, and quantities for the item
bubbles shown on the drawings.
Listed here are the types of drawings and documents typically found on a
Document List (DL):
AA09xxxxxxA – indicates a model number assembly drawing. Drawings
of this type are used when lower-level assembly drawings are not
required.
AA09xxxxxxS – indicates a model number assembly schematic.
AA09xxxxxxI – indicates a model number installation drawing. These
drawings contain the information necessary to install the product,
including size, air/water and power requirements, wiring pin-out
information, and any other special information necessary to install the
product. Generally, the drawings are envelope drawings of the product,
and internal detail is minimized.
AA08xxxxxxA – indicates an assembly drawing that shows how the
product is put together.
AA658080xxxxA – indicates an assembly drawing that shows how the
product is put together.
AA08xxxxxxS – indicates an assembly schematic that shows how the
product is wired.
10/4/07
Introduction
p/n: 6510020208