Honeywell Precision Platform 4022 Series System Manual page 13

Precision Platform 4022 Scanner Contents
Figure 6-4 Termination Board ...........................................................................................................6-12
Figure 6-5 Termination Board Schematic 1 of 6..............................................................................6-20
Figure 6-6 Termination Board Schematic 2 of 6..............................................................................6-21
Figure 6-7 Termination Board Schematic 3 of 6..............................................................................6-22
Figure 6-8 Termination Board Schematic 4 of 6..............................................................................6-23
Figure 6-9 Termination Board Schematic 5 of 6..............................................................................6-24
Figure 6-10 Termination Board Schematic 6 of 6............................................................................6-25
Figure 6-11 Logic PCB Assembly......................................................................................................6-26
Figure 6-12 Contents of 4604-02 PMP Enclosure ............................................................................6-28
Figure 6-13 Radiation Fault Protect PCB Assembly.......................................................................6-34
Figure 7-1 4022-40 Scanner with Remote PMP .................................................................................7-2
Figure 7-2 4022-40 Wire Calender Scanner Head Separation .........................................................7-7
Figure 9-1 Power Track Clearance......................................................................................................9-9
Figure 9-2 Cable Clamp Position ......................................................................................................9-10
Figure 9-3 Upper and Lower Head Carriages ................................................................................9-14
Figure 9-4 Replacing the Motor Drive Belt......................................................................................9-20
Figure 9-5 Head Drive Belt Tensiometer .........................................................................................9-22
Figure 9-6 Adjusting the Belt Support Brackets .............................................................................9-28
Figure 9-7 Clutch Assembly ..............................................................................................................9-29
Figure 9-8 Motor Wiring Details .......................................................................................................9-34
Figure 9-9 Head Separation Clutch Controls ..................................................................................9-38
Figure 9-10 High Pressure Air Manifold .........................................................................................9-43
Figure 9-11 Low Pressure Air Manifold .......................................................................................... 9-44
Figure 9-12 Head Air Purge...............................................................................................................9-45
Figure 9-13 ECU and Temperature Controls ..................................................................................9-48
List of Tables
Table 2-1 Minimum Separation of Signal and Power Cables .......................................................2-12
Table 2-2 Maximum Distances for Communication Network Cables.........................................2-13
Table 2-3 Motors and Blowers for Low Pressure Air.....................................................................2-15
Table 2-4 Head Temperature Trim Heater Control Settings ........................................................2-17
Table 2-5 Sheet Guide Heater Jumper Setting ................................................................................2-18
Table 2-6 Air Wipe Heater Control Settings....................................................................................2-18
Table 2-7 Configurations for Cooling Heads and PMP Enclosure Depending on Site and
System Characteristics................................................................................................................2-20
Table 4-1 Motor Controller Settings .................................................................................................4-11
Table 4-2 Air Wipe Heater Controller Settings ...............................................................................4-17
Table 5-1 Head Movement Monitoring and Control Switches ....................................................5-10
Table 5-2 Scan control panel buttons and switches........................................................................5-14
ix
p/n 6510020208 10/18/07