Linear Encoder Manufactured By Heidenhain Corporation - Mitsubishi Electric MELSERVO-J3 Series Instruction Manual

3. LOAD SIDE ENCODER

3.2.2 Linear encoder manufactured by Heidenhain Corporation

(1) For LC491M or LC192M (Absolute type)
(a) Cable structure
Prepare a cable based on the following structure diagram.
Servo amplifier
CN2L
When using an 1) Option manufactured by Heidenhain Corporation
optional cable (This should be prepared by the customer.) (Note)
When producing 2) Connector set MR-J3CN2
a load side (Option manufactured by
encoder cable Mitsubishi Electric
Corporation)
(Refer to section 3.4.)
Note. For details, contact with Heidenhain Corporation.
POINT
When the absolute position detection system is configured, the MR-J3BAT
battery is not required.
POINT
This linear encoder is of four-wire type. When using any of these encoder, set
parameter No.PC26 to "1
Load side encoder cable
1)
3)
2)
Load side encoder cable
3) Junction connector (This
should be prepared by
the customer.)
17-pin coupling (female)
291697-26
(manufactured by
Heidenhain Corporation)
" to select the four-wire type.
Linear encoder
LC491M or LC192M
4) Output cable
Cable
LC491M
4) 337 439-
m
(manufactured by
Heidenhain
Corporation)
(This should be
prepared by the
customer.)
3 - 7
Output cable
LC192M
4) 343 421-
m
(manufactured by
Heidenhain
Corporation)
(This should be
prepared by the
customer.)