Mitsubishi Electric MELSERVO-J3 Series Instruction Manual page 121

5. PARAMETERS
No. Symbol
PE28 For manufacturer setting
PE29
Do not change this value by any means.
PE30
PE31
PE32
PE33
PE34 **FBN2 Fully closed loop control feedback pulse electronic gear 2 numerator
Used to set the numerator of the electronic gear to the motor encoder pulse. Set the
electronic gear so that the number of pulses for one servo motor revolution is converted to
the resolution of the load side encoder.
When the set value is "0", it is identified as "1" inside.
PE35 **FBD2 Fully closed loop control feedback pulse electronic gear 2 denominator
Used to set the denominator of the electronic gear to the motor encoder pulse. Set the
electronic gear so that the number of pulses for one servo motor revolution is converted to
the resolution of the load side encoder.
When the set value is "0", it is identified as "1" inside.
PE36
For manufacturer setting
PE37
Do not change this value by any means.
PE38
PE39
PE40
Name and Function
5 - 20
Initial Setting
Unit
Value Range
0000h
0000h
0000h
0000h
0000h
0000h
1 0
to
32767
1 0
to
32767
0.0
0.00
0.00
0000h
0000h