Mitsubishi Electric MELSERVO-J3 Series Instruction Manual page 157

Print Data *Manual Number
Aug., 2009 SH(NA)030056-D 4. Additional NFB changed to MC in the figure
Instructions (2)
4. Additional Figure changed
Instructions (5)
Conformance with Contents changed in (2)Installation and (3)Short circuit rating
UL/C-UL Standard Description of conformance with the standard changed
Description of <About the wires used for wiring> moved
Section 1.3 (1) Item of "Mounting closely" added
Vibration condition added
Item of "Output" added
Rated current with item of "Power supply input" added
Maximum current with item of "Control circuit power supply input"
added
Note changed
Section 1.3 (2) Vibration condition added
Item of "Output" added
Rated current with item of "Power supply input" added
Maximum current with item of "Control circuit power supply input"
added
Section 1.4 Items of "Robust disturbance compensation", "Advanced Gain
search", and "Input signal selection (Device settings)" added
Section 1.5.1 Parameter No.PE08 value changed
Section 1.6 (2) Note (Note 3) added above 4 in the power supply symbol section
Section 1.7 "The same combinations apply to the models with
electromagnetic brakes" changed to "The same combinations
apply to the models with an electromagnetic brake and the
models with a reduction gear"
Section 2.1 Items of "Alarm occurrence timing chart (section 3.6)" and
"Grounding (section 3.12)" added
Section 2.2 (1) to Figures of connection between the servo amplifier and the servo
(6) motor changed
Section 2.2 (1), "Use only one of power factor improving DC reactor or power
(2), (4) to (8) factor improving AC reactor" added at the end of the paragraph
Section 2.2 (1) to Note 8 and Note 9 added
(3)
Section 2.2 (4) Note 9 and Note 10 added
Section 2.2 (5), (7) Note 9 and Note 10 added
NFB added between Cooling fan and Cooling fan power supply
Section 2.2 (6) Note 10 and Note 11 added
NFB added between Cooling fan and Cooling fan power supply
Section 2.2 (8) Note 11 and Note 12 added
NFB added between Cooling fan and Cooling fan power supply
Section 2.3 Note 11 sentence partially changed
Description of "Q170MCPU" and "QD74MH
Section 2.4 Sentence below POINT section changed
"For the appearances and connector... refer to the outline
drawings of servo amplifier in chapter 6" changed to"...refer to
chapter 7 OUTLINE DRAWINGS"
Reference for the detail of CN5(USB connector) changed
"Refer to section 11.6 of the MR-J3-
Instruction Manual" changed to "Refer to section 11.8 of the MR-
J3-
Revision
B Servo Amplifier Instruction Manual"
" added to Note
B Servo Amplifier