Pci/Pnp Setup - Advantech ITA-1710 User Manual

4.2.3

PCI/PnP Setup

Select the PCI/PnP tab from the ITA-1710 setup screen to enter the Plug and Play
BIOS Setup screen. You can display a Plug and Play BIOS Setup option by highlight-
ing it using the <Arrow> keys. All Plug and Play BIOS Setup options are described in
this section. The Plug and Play BIOS Setup screen is shown below.
 Clear NVRAM
Set this value to force the BIOS to clear the Non-Volatile Random Access Mem-
ory (NVRAM). The Optimal and Fail-Safe default setting is No.
 Plug and Play O/S
When set as "No", BIOS will configure all devices in the system. When set as
"Yes", if users have installed plug and play O/S, O/S will configure plug and play
devices that don't need to start. The default setting is No.
 PCI Latency Timer
Use this to adjust the PCI Latency Timer. This option sets the latency of all PCI
devices on the PCI bus. The Optimal and Fail-Safe default setting is 64.
Allocate IRQ to PCI VGA

Set this value to allow or stop the system from giving the VGA adapter card an
interrupt address. The Optimal and Fail-Safe default setting is Yes.
 Palette Snooping
 Set this value to allow the system to modify the Palette Snooping settings. The
Optimal and Fail-Safe default setting is Disabled.
PCI IDE BusMaster

Set this value to allow or prevent the use of PCI IDE Busmastering. The Optimal
and Fail-Safe default setting is Disabled.
Figure 4.18: PCI/PnP Setup
43 ITA-1710 User Manual