Advantech ITA-1710 User Manual page 41

4.2.2.2 IDE Configuration
 IDE Configuration
The default setting is "Enabled". It will enable all SATA resources when enabled.
 Enhanced Mode
This has two options: IDE and AHCI. The default setting is "IDE", Legacy IDE
Mode Setting.
 Primary/Secondary/Third/Fourth IDE Master and Slave
While entering setup, BIOS auto detects the presence of IDE devices. This dis-
plays the status of auto detection of IDE devices.
– Type: Select SATA driver type. The options are [Not installed], [Auto],
[CD/DVD] and [ARMD].
– LBA/Large Mode: Enable or disable LBA mode.
– Block (Multi-Sector Transfer): Enable or disable multi-sector data trans-
fer.
– PIO Mode: Select PIO mode.
– DMA Mode: Select DMA mode.
– S.M.A.R.T.: Select intelligent monitoring, analysis and report technol-
ogy
– 32Bit Data Transfer: Enable or disable 32-bit data transfer.
 Hard Disk Write Protect
Enable or disable device write protect feature. This item is only available when
the device is visited through BIOS. And it is only effective under DOS. The
default configuration is "Disabled".
 IDE Detect Time Out (Sec)
This item allows users to detect ATA/ATAPI device's time out value. The default
value is "35".
Figure 4.6: IDE Configuration
31 ITA-1710 User Manual