Pci/Pnp Setup - Advantech ARK-5260 User Manual

Embedded ipc

Hide thumbs Also See for ARK-5260:

Table of Contents

3.2.3

PCI/PNP Setup

Select the PCI/PnP tab from the ARK-5260 setup screen to enter the Plug and Play

BIOS Setup screen. Highlighting a Plug and Play BIOS Setup option by using the

<Arrow> keys displays a description in the righthand panel. All Plug and Play BIOS

Setup options are described in this section. The Plug and Play BIOS Setup screen is

shown below.

3.2.3.1

Clear NVRAM

Set this value to force the BIOS to clear the Non-Volatile Random Access Memory

(NVRAM). The Optimal and Fail-Safe default setting is No.

3.2.3.2

Plug and Play O/S

Set this value to allow the system to modify the settings for Plug and Play operating

system support. The Optimal and Fail-Safe default setting is No.

3.2.3.3

PCI Latency Timer

Use this to adjust the PCI Latency Timer. This option sets the latency of all PCI

devices on the PCI bus. The Optimal and Fail-Safe default setting is 64.

3.2.3.4

Allocate IRQ to PCI VGA

Set this value to allow or stop the system from giving the VGA adapter card an inter-

rupt address. The Optimal and Fail-Safe default setting is Yes.

3.2.3.5

Palette Snooping

Set this value to allow the system to modify the Palette Snooping settings. The Opti-

mal and Fail-Safe default setting is Enabled.

3.2.3.6

PCI IDE BusMaster

Set this value to allow or prevent the use of PCI IDE Busmastering. The Optimal and

Fail-Safe default setting is enabled.

3.2.3.7

Off Board PCI/ISA IDE card

Set this value to allow an add-on PCI/ISA IDE card to be selected. The Optimal and

Fail-Safe default setting is Auto.

Figure 3.12 PCI/PNP Setup

ARK-5260 User Manual

Table of Contents