2.8
Configuration and Setup
The IQ plus 810 configuration is the same as the normal IQ plus 810. Please refer to the 800/810 Installation
and Operation manual , PN 42100 for further details on configuring your indicator.
Enable the configuration by turning on the switch at the top of the circuit board mounted on the door of the
enclosure. Configure the indicator at this time.
2.8.1
Setpoint Operation
The standard IQ plus 810 unit comes with a four
channel output relay board. The relays are connected
to outputs 1, 2, 3, and 4.
2.8.2
Digital Inputs
The signal BATSTART is connected to digital input
#1. The signal BATSTART is connected to digital
input #2. Digital input #3 can be used by the operator
as needed.
12
IQ 810XCPD Installation Manual