Table of Contents
Advertisement
Section II - INSTALLATION FOR USE
Preparation Of Mower
Carefully dismantle wooden shipping crate from around the components. Cut retaining straps and separate the parts.
The collection system will have various parts located inside. Remove and sort all parts for easy identification.
NOTE: Before each step of assembly it will help to study the exploded drawings.
Battery Cover Removal
The plastic battery cover should be removed to allow for access when unit is fully assembled. Start by loosening the
two wing nuts on both sides of the cover and remove the cover. See Figure A.
Figure A
Remove Battery Cover
Rear Main Frame Installation
Note: It is recommended that someone assist you in attaching the rear Main Frame Channel P#(B2103).
Lift the Main Frame Channel P#(B2103) into position aligning the right set of mounting holes on the Main Frame
Channel with the existing holes on the rear bumper of the mower, as shown in Figure B.
Figure B
Mount Holes
6
Advertisement
Table of Contents
