Table of Contents
Advertisement
2-10 Aluminum Grass Container
Installation
NOTE: It is recommended that (3) people assist in
mounting the container.
With three people available, two can lower the container
onto the frame while the third person inserts the pivot
pins P#(K0172) through the holes. Insert the pins from
the outside to the inside. Secure with (1) 5/8" washer
P#(K0058) and (1) 5/32" x 2-5/8" hair pin clip P#(K0088)
per pivot pin (Figure 2-10).
Reattach the bottom ends of the door opening linkages
to the main frame by using (1) Rue-Ring cotter pin
P#(K1437) per side.
To test the functionality of the dump mechanism, pull the
lift handle away from the unit, and lift upward (Page 10).
The door of the container should open and the box
should pivot clockwise towards the ground.
Figure 2-10.
Pivot Pins
(1) Hair Pin Clip
(Per Side)
2-11 Dump Mechanism Adjustment
The linkage may be adjusted in two places, at the
adjusting screw P#(K1435) and the latch assembly
items. See page 10 for visual clarification. To change the
door closure tightness, screw the adjusting screw
(Figure 2-11a.) in or out. To adjust the latch, change the
length of the latch rod by screwing the latch adjusting
ball joint in or out. The latch hook pivot should be in the
middle of the slot in the latch hook pivot plate. Slide the
pivot back or forth and then re-tighten. Figure 2-11b.
shows the aluminum grass container mounted to the
main frame assembly.
Figure 2-11a.
Figure 2-11b.
Grass Container
Attached To The
Main Frame Assembly
9 9
Adjusting Screw
Cotter Pin
Advertisement
Table of Contents
