Table of Contents
Advertisement
Slide the wheel to be mounted onto the cen‐
#
tring pin and push it on.
Notes on fitting an emergency spare wheel
#
(
page 544).
/
& WARNING Risk of injury from tightening
wheel bolts and nuts
If you tighten the wheel bolts or wheel nuts
when the vehicle is raised, the jack could tip.
Only tighten wheel bolts or wheel nuts
#
when the vehicle is on the ground.
Be sure to observe the instructions and
#
safety notes on "Changing a wheel"
(
page 534).
/
For safety reasons, only use wheel bolts
#
which have been approved by Mercedes-
Benz and for the wheel in question.
Tighten the wheel bolts evenly in a diagonal
#
pattern in the order indicated until they are
finger-tight.
Unscrew the centring pin.
#
Tighten the last wheel bolt until it is finger-
#
tight.
Lower the vehicle (
page 543).
/
#
Lowering the vehicle after a wheel change
Requirements:
The new wheel has been fitted
R
(
page 542).
/
Place the ratchet onto the hexagon nut of the
#
jack so that the letters "AB" are visible.
To lower the vehicle: turn the ratchet of the
#
jack anti-clockwise.
Wheels and tyres 543
Tighten the wheel bolts evenly in a diagonal
#
pattern in the order indicated
a maximum of 80 Nm.
Tighten the wheel bolts evenly in a diagonal
#
pattern in the order indicated
the specified tightening torque of 130 Nm.
& WARNING Risk of injury through incor‐
rect tightening torque
The wheels could come loose if the wheel
bolts or wheel nuts are not tightened to the
prescribed tightening torque.
Make sure the wheel bolts or wheel
#
nuts are tightened to the prescribed
tightening torque.
If you are not sure, do not move the
#
vehicle. Consult a qualified specialist
workshop and have the tightening tor‐
que checked immediately.
Check the tyre pressure of the newly moun‐
#
ted wheel and adjust accordingly.
1
to
5
with
1
to
5
to
Hide quick links:
Advertisement
Table of Contents
