Mercedes-Benz GLB Owner's Manual page 495

492 Maintenance and care
* NOTE Damage due to unsuitable car
wash
Before driving into a car wash make
#
sure that the car wash is suitable for
the vehicle dimensions.
Ensure there is sufficient ground clear‐
#
ance between the underbody and the
guide rails of the car wash.
Ensure that the clearance width of the
#
car wash, in particular the width of the
guide rails, is sufficient.
To avoid damage to your vehicle when using a
car wash, ensure the following beforehand:
Active Distance Assist DISTRONIC and the
R
HOLD function are deactivated.
the side windows and sliding sunroof are
R
completely closed.
the blower for the ventilation/heating is
R
switched off.
the windscreen wiper switch is in position
R
g.
the key is at a minimum distance of 3 m
R
away from the vehicle, otherwise the tailgate
could open unintentionally.
in car washes with a conveyor system: neu‐
R
tral i is engaged.
% In car washes with a conveyor system: if you
would like to leave the vehicle while it is
being washed, make sure the key is located
in the vehicle. The park position j is other‐
wise automatically engaged.
% If, after the car wash, you remove the wax
from the windscreen and wiper rubbers, this
will prevent smearing and reduce wiper
noise.
Information on using a high-pressure cleaner
& WARNING Risk of an accident when
using high-pressure cleaners with circu‐
lar jet nozzles
The water jet of a circular jet nozzle (dirt
grinder) can cause externally invisible dam‐
age to the tyres or chassis parts.
Components damaged in this way may unex‐
pectedly fail.
Do not use high-pressure cleaners with
#
circular jet nozzles to clean the vehicle.
Have damaged tyres or chassis parts
#
replaced immediately.
To avoid damage to your vehicle, observe the fol‐
lowing when using a high-pressure cleaner:
keep the key at least 3 m away from the vehi‐
R
cle. Otherwise the tailgate could open unin‐
tentionally.
maintain a distance of at least 30 cm to the
R
vehicle.
vehicles with decorative foil: parts of your
R
vehicle are covered with a decorative foil.
Maintain a distance of at least 70 cm
between the foil-covered parts of the vehicle
and the nozzle of the high-pressure cleaner.
Move the high-pressure cleaner nozzle
around whilst cleaning. The water tempera‐
ture of the high-pressure cleaner must not
exceed 60 °C.