Mercedes-Benz GLB Owner's Manual page 207

204 Driving and parking
j Park position
k Reverse gear
i Neutral
h Drive position
Engaging reverse gear R
Depress the brake pedal and push the
#
DIRECT SELECT lever upwards past the first
point of resistance.
The transmission position display k is
shown in the multifunction display.
Engaging neutral N
Depress the brake pedal and push the
#
DIRECT SELECT lever up or down to the first
point of resistance.
The transmission position display i is
shown in the multifunction display.
Subsequently releasing the brake pedal will
allow you to move the vehicle freely, e.g. to push
it or tow it away.
Proceed as follows if you want the automatic
transmission to remain in neutral i
the ignition is switched off or the driver's
door is opened:
Start the vehicle.
#
Depress the brake pedal and engage neutral
#
i when the car is stationary.
Release the brake pedal.
#
Switch the ignition off.
#
% If you then exit the vehicle leaving the key in
the vehicle, the automatic transmission
remains in neutral i.
Engaging park position P
Observe the notes on parking the vehicle
#
( page 215).
/
Depress the brake pedal until the vehicle is
#
stationary.
When the vehicle is stationary, press button
#
j.
Park position is only engaged when the
transmission position display j is shown in
the multifunction display. If no transmission
position display j appears, secure the vehi‐
cle to prevent it from rolling away.
i even if Park position j is engaged automatically if one
of the following conditions is met:
you switch off the ignition when the vehicle
R
is stationary and the transmission is in posi‐
tion h or k.
you open the driver's door when the vehicle
R
is stationary or when driving at a very low