User Manual
GFK-2409B
3.
Figure 42:
4.2.1
Adding Genius, I/O Devices
To add Genius devices to a Genius Bus, select the Genius I/O item in the Project tree. Now
the I/O Assignments table is displayed which lists the Genius Devices that are assigned to
the various SBAs (Serial Bus Addresses).
Figure 43:
To add a Genius, I/O device to this Genius Bus:
The Max-ON RX3i Configuration Utility
Double-click on the Secondary Bus Controller in order to configure it's parameters or
select the Busses > Properties... or Module > Properties... menus. Enter the module's
location in the RX3i main rack and it's status address. A suggested practice is to
address Genius bus controllers at high addresses. This leaves the low addresses
available for Input devices such as field sensors. (Note: The input address must be set
to less than %I02017.)
Chapter 4
Oct 2019
35