Emerson PACSystems RX3i User Manual page 21

User Manual
GFK-2409B
For CPU B:
1. Open the Hardware Configuration for PLC_B_HW target in the Max-ON RX3i Project.
2. Configure the PLC hardware for PLC B.
3. Store the new hardware configuration into CPU B.
4. Set the time and date for CPU B.
Step 4 - Add Your Application Logic
Using Logic Developer PLC, open the PLC_COMMON_CODE Target folder and add your
application logic after the call to the subroutine named HBR_000.
Figure 17
If you are using an Existing Project
If you have developed the application previously, then you may copy and paste the Max-ON
RX3i logic into the existing Project. A Machine Edition Toolchest drawer is also provided that
may be used to copy the Max-ON Blocks into the Project.
If this is a New Application
Add your application logic into the project folder directly after the CALL to the hbr_000
Block in _MAIN Rung 3.
Building a Max-ON RX3i Hot Standby Application
• CPU Memory
• CPU SNP ID
• Genius Bus Controllers
• I/O Devices on the Genius Bus (or Busses)
• Ethernet Modules
Ethernet IP Address and Subnet Mask
—
Device Status Address
—
Ethernet Global Data (EGD) Exchanges for Ethernet NIUs
—
Chapter 3
Oct 2019
17