Emerson PACSystems RX3i User Manual page 80

User Manual
GFK-2409B
MxnCons1 (Primary LAN)
Offset (Byte.Bit) Variable
Status
TimeStamp
0.0
MxnProd2 (Secondary LAN)
Offset (Byte.Bit) Variable
Status
0.0
MxnCons2 (Secondary LAN)
Offset (Byte.Bit) Variable
Status
TimeStamp
0.0
Configure Ethernet Interface for Ethernet I/O LANS for PLC A (if used)
Configure the Ethernet Interfaces used in conjunction with the Ethernet NIUs. Add the
Ethernet Interface module(s) to the appropriate slot(s) in the Hardware Configuration for
PLC A. You will also need to configure this Module's EGD information to match the
definitions of your ENIU EGD exchanges.
Figure 80
Please note that only 4 Ethernet Modules may be added to an RX3i Main Rack.
Configure Genius Bus Controllers for PLC A (if used)
Use the Genius Bus Primary/Secondary configuration summary from the Max-ON RX3i
Configuration Utility as a guide for configuring the Genius busses in the system.
Configuring the Hot Standby Redundancy CPUs
Ref Address Ignore
%W49620
%W49621
%W40077
Ref Address Ignore
%W49629
%W40001
Ref Address Ignore
%W49630
%W49631
%W40153
Chapter 6
Length Type
1 WORD
4 WORD
76 WORD
Length Type
1 WORD
76 WORD
Length Type
1 WORD
4 WORD
76 WORD
Oct 2019
76