Polycom RMX 2000 Migration Manual page 6

b: Install the CNTL 2000 Module
1
Slide in the CNTL 2000 Module. Push the CNTL 2000 Module firmly into the Backplane, making
sure it is properly seated in its slot.
2
Ensure that the metal ejector lever is fully retracted into its housing.
3
Tighten the captive screws on the front panel of the RMX that secure the CNTL 2000 Module.
c: Installing the RTM LAN Card(s)
1
Slide in the replacement RTM LAN card.
2 Push the RTM LAN card firmly into the Backplane, making sure it is properly seated in its slot.
Ensure that the ejector levers are fully retracted into their housings (see "Appendix B - Using the
Ejector Lever(s)" on page 11).
3
Tighten the captive screws on the rear panel of the RMX that secure the RTM LAN card.
4
Repeat the procedure for the other RTM LAN card.
d: Connecting Cables
Do not remove the protective caps from LAN1, LAN3 and ShMG ports.
On the RMX 2000 connect the following cables to the back panel:
• Power cable
• RTM LAN: LAN cable to LAN 2 port
6