Polycom RMX 2000 Migration Manual page 3

a: Removing the Existing Control (CNTL) Module from the MCU
1
Unscrew the captive screw on the front panel of the RMX 2000 that secure the Control (CNTL)
Unit.
2
Use the handle to pull the Control (CNTL) Unit. out of its slot in the Backplane.
3
Carefully slide the Control (CNTL) Unit. out through the front panel.
b: Removing the Existing Power Supply Drawer from the MCU
1
Unscrew the captive screws on the front panel of the RMX 2000 that secure the Power Supply.
2 Use the handle to pull the Power Supply Module out of its slot in the Backplane.
3
Carefully slide the Power Supply Module out through the front panel.
c: Removing the Existing MPM/MPM+/MPMx Card(s) from the MCU
1 Unscrew the captive screws and remove the Media card(s)
2
Use the ejector levers (see "Appendix B - Using the Ejector Lever(s)" on page 11) to pull the RTM IP
card out of its slot in the Backplane.
3
Carefully slide the MPM/MPM+/MPMx card out through the front panel.
Remove all MPM/MPM+/MPMx cards from the MCU. Starting with version 8.3 different types of
Media cards cannot be installed simultaneously on a single MCU.
3