Installation - Inficon Micro GC Fusion Installation Sheet

Installation Sheet

Installation

The external sample conditioner can be installed on the 2-module Micro GC Fusion. The external sample conditioner is factory pre-
assembled, and can be easily mounted onto Micro GC Fusion during instrument installation.
1 Verify that the contents of the accessory kit are correct.
2 Remove all of the parts from the packaging.
3
Attach the external sample conditioner slide plate to the bottom of the device using a 2.5 mm hex driver.
4 Attach the 1/16 in. sample transfer line with the rubber insulation sleeve onto the external sample conditioner using a 5/16 in. open-
ended wrench.
5 Slide the bottom mounting bracket underneath Micro GC Fusion and align the feet with the dedicated holes.
4 / 19
CAUTION
Use caution when mounting the external sample conditioner to a fixed position. Ensure there is enough room
to disconnect the power cord when needed.
074-732-P1A Micro GC Fusion External Sample
Conditioner Installation Sheet