Polaris RZR 800 2013 Manual page 111

23. Inspect the crankshaft gear (Q) for broken or worn
teeth. If the crankshaft gear does not need to be
replaced, it does not need to be removed. If the
crankshaft gear is damaged, remove the crankshaft
gear with the Flywheel Puller (PN 2871043).
24. Install the two puller bolts (R). Tighten the puller bolts
up so that the bolts are at equal length.
25. Install the Flywheel Puller (PN 2871043) and remove
the crankshaft gear, if needed.
26. Rotate the water/oil pump gear (S), so that all four
27. Inspect the oil pump rotors for wear. Mark the rotors
9924707 - 2013–2014 RZR 800 Service Manual
© Copyright 2013 Polaris Sales Inc.
bolts are visible though the gear. Remove the four
bolts with a hex wrench. Pull out the pump.
with a white pen to ensure upon reassembly that the
correct sides of the rotors are installed and mesh
with the same edges as previously installed.
NOTE: If replacing the
replacement rotors will fit into the original oil/
water pump housing.
ENGINE
3
old rotors, new
3.49