Polaris RZR 800 2013 Manual page 87

39. Disconnect the engine coolant temperature (ECT)
sensor harness and the bypass coolant hose.
40. Loosen the hose clamp and remove the lower
coolant hose from the water pump cover inlet and
drain coolant into a suitable container.
41. Remove the filler neck pressure cap to relieve the
cooling system vacuum.
NOTE: Use a portable wet-vac or syphon to
prevent any coolant from spilling.
42. Remove the upper coolant hose from the thermostat
housing outlet to relieve any coolant vacuum created
in the engine. Allow engine coolant to completely
drain. Properly dispose of the engine coolant /
antifreeze.
43. Remove the (+) positive battery cable from the
starter motor terminal and (-) negative battery cable
from the starter motor engine mount.
44. Remove RH engine mount fastener.
45. Remove the (2) lower bolts that retain the LH
9924707 - 2013–2014 RZR 800 Service Manual
© Copyright 2013 Polaris Sales Inc.
transmission mount to the frame.
ENGINE
3
3.25