Polaris RZR 800 2013 Manual page 84

ENGINE
25. Remove the airbox and throttle body from the vehicle
as an assembly. Take care in not allowing the throttle
cable to bend excessively or kink. Carefully place the
assembly on the floor next to the vehicle. Insert a
shop towel into the engine intake adaptor to prevent
dirt from entering the engine.
NOTE: Ensure throttle cable is not being
excessively bent or kinked while removed from
the vehicle.
26. Mark the fuel injector harnesses to identify MAG and
PTO harness connections to aid during reassembly.
Disconnect the fuel injector harnesses.
NOTE: The fuel injector harness connector and
locking spring is bonded to the fuel injectors
with an epoxy mix. DO NOT attempt to
disconnect the connector from the fuel injectors.
Damage will occur to the injector and/or harness
if attempting to separate at that location.
Separate the fuel injector from the vehicle by
disconnecting at the end of the harness as
shown.
IMPORTANT: Take note of PTO and MAG fuel
injector harness
disconnecting them. The harnesses are different
and can not be connected incorrectly (PTO -
Gray; MAG - Black).
3.22
connectors before
9924707 - 2013–2014 RZR 800 Service Manual
© Copyright 2013 Polaris Sales Inc.
27. Disconnect the fuel line from the fuel injector rail by
slightly squeezing the lock tabs and gently pushing
the connector lock out. To separate the lines, pull the
fuel line from the tank strait down.
28. Disconnect the shift cable from the transmission bell
crank.