Table of Contents
Advertisement
P R I M A R Y- S E C O N D A R Y C O N F I G U R AT I O N
Primary-Secondary Configuration:
This function will allows you to link units together to run in a Primary-Secondary setup. In a Primary-
Secondary set up one unit will act as the controlling unit and the others will react to the controlling
units built-in programs. Any unit can act as a Primary or as a Secondary however, only one unit can be
programmed to act as the "Primary."
Primary-Secondary Connections and Settings:
1. Daisy chain your units via the XLR connector on the rear of the unit. Use standard XLR data cables
to link your units together. Remember that the Male XLR connector is the input and the Female XLR
connector is the ouTput. The first unit in the chain (primary) will use the female XLR connector only.
The last unit in the chain will use the male XLR connector only.
2. Set the "Primary" unit to your desired mode of operation.
3. On the "Secondary" units press the MODE button until "SLAu" is dis- played. The unit is now set as
the "SEC" unit. Each secondary unit must be set to the same setting.
4. Connect the first "Secondary" unit to the "Primary" unit, and the "Secondary" unit should now start
follow the "Primary" unit.
P O W E R C O R D D A I S Y- C H A I N
With this feature you can connect the fixtures to one another using the IEC input and output
sockets. The quantity that can be connected is 10 fixtures maximum. After 10 fixtures you will
need to use a new power outlet. They must be the same fixtures. DO NOT mix fixtures.
NOTE: Fixtures cannot be power cord daisy chained and run by battery power.
W I F LY S E T U P
With this feature you are able to control the unit with DMX without the need of XLR cables. Your
DMX controller must be connected to a ADJ WiFly TransCeiver to use this function. You are able to
communicate up to 2500 feet/760 meters (open line of sight).
NOTE: The ADJ RFC control must be set to OFF to use this function.
1. Turn on the WiFly function using the WiFly On/Off switch and set the antenna to either a up position
or down position.
2. Follow the instructions on page 14 to set the Wireless address. The address must match the address
set on the WiFly Transceiver.
3. After you have set the WiFly address, follow the DMX instructions on pages 12-13 to select your
desired DMX Channel mode and set your DMX address.
4. Apply power to the ADJ WiFly Transceiver. The fixture must be set up first before you apply power
to WiFly Transceiver.
5. If everything is set up properly and the fixture is receiving a Wireless signal, Wireless status LED
next to LED screen will glow green.
Note: If the sync does not work, switch the WiFly power off then on again.
16
Advertisement
Table of Contents
